Schaner's Waste Water Products: Polymer Cleaner, Struvite Removal & Odor Control for the Belt Filter Press

Scahner's Icon

Schaner's WWP

Home

Belt Blinding
Polymer Cleanup
Struvite/Vivianite
Odor Control
Misc. Products

Product Matrix
POLY-GONE
POLY-GONE GOLD
POLY-SUPPRESS
Polygone Lines
WASH-UP
HALT II
P.O.C.
W.W.P.C.
POLY-GONE HYBOD

Pulsafeeder
PULSAtron Pumps

Representatives/
Distributors

References

Demonstration

Please use the following form to request a demonstration in your facility:

 

Name:

Facility:

Address1:

Address2:

City:

State:

Zip:

Phone:

Fax:

E-Mail:

Product:

Comments:

 

POLY-GONE Demonstration Checklist:

  1. We need you to provide a place for us to hook up the injection pump into your wash water line at the press. This must be prior to where the wash water lines split into upper and lower wash boxes. injection fitting we provide is 1/2" Male National Pipe Thread.
  2. Usually the best places on the Wash Water Line are at the pressure gauge or at the pump drain plug.
  3. Remove the gauge or plug and install a "T" and a valve and reduce it to 1/2" Female, that way when we arrive, you will not have to turn the press off for us to connect the pump.

    The Demonstration:

    1. Ideally, you will be running your press when we arrive and you have the valve and injection point ready.
    2. We will hook up our pump and product while you make your final adjustment to the belt press.
    3. Prior to turning on our pump, you can make observations as to over-all condition, visual drainage, feel of the belt, and note any flooding or blinding that may already be apparent. visual inspection make note of the following: belt speed, belt tension, sludge feed, and polymer feed.
    4. We will then turn on our equipment. Our initial setting for heavy duty shock cleaning will be approximately 1 gallon to 2,800 gallons of wash water. approximately 20 to 30 minutes (three fill turns of the belt), we will ask you to note any changes you have seen. During this time however, we request that you do not change any settings. changes have been noted, will will adjust our pump into the maintenance mode: 16,000:1 dilution rate for POLY-GONE.
    5. Now we will have some fun and experiment! If you have VSP sludge pumps, we may ask you to increase the sludge and leave the polymer setting the same. We my ask you to change the belt speed, or we may ask you to reduce polymer settings. After we have completed the dmonstrations, we would appreciate your comments as to any observations that you may have made.

Scahner's Icon

info@struvite.com

(800) 933-9109
(877) 887-6617 fax

302 Aspen Lane
Dundee, MI 48131
(734)529-5700 (734)529-5722 fax

Copyright © 1997-2003 Schaner's Waste Water Products, Inc.